Difference between revisions of "CNC Bender v11-20091229"
From ATTWiki
| Line 47: | Line 47: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | * CNC Bender can now check for the existence of a broken mandrel after a mandrel extraction. | + | * CNC Bender can now check for the existence of a broken mandrel after a mandrel extraction.<br><br> |
| − | * If the mandrel is broken, then the | + | * If the mandrel is broken, then the CNC Bender logic requires the operator to place the tube in a tube destroyer to crush the tube to prevent it from being used in other machinery in the cell.<br><br> |
</td> | </td> | ||
| Line 59: | Line 59: | ||
<br><br> | <br><br> | ||
| − | |||
=Other Pages= | =Other Pages= | ||
Revision as of 21:43, 30 December 2009
|
|
|
Contents |
ENHANCE- Updates to CNC Processor to improve motion command logic
|
|
NEW - Tube Mandrel Check and Destroyer Feature
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Final Feed Clearance
