Difference between revisions of "CNC Bender v12-20100316"
From ATTWiki
| Line 28: | Line 28: | ||
<table> | <table> | ||
<tr valign=top> | <tr valign=top> | ||
| − | <td width= | + | <td width=100> |
This new bend option allows you to fine-tune the calculated feed speed during Feed Bending. | This new bend option allows you to fine-tune the calculated feed speed during Feed Bending. | ||
<br><br> | <br><br> | ||
Revision as of 13:02, 16 March 2010
|
|
|
Contents |
NEW - Feed Speed Percentage Adjustment for Feed Bend Mode
|
This new bend option allows you to fine-tune the calculated feed speed during Feed Bending.
|
|
| Value Type | The value is entered as a floating point percentage. |
| + or - | The value can be positive or negative. |
| Impact of Negative Values | Negative values slow the calculated speed of the Feed axis. |
| Example + | A value of +100 would double the speed of the Feed axis during draw bending. |
| Example - | A value of -100 would set the speed at 0 for the Feed axis during draw bending. |
|
The table at the right shows an example of a -10% change in the processlist: |
See vel0 calculated at 100%: |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
