Difference between revisions of "CNC Bender v12-20100316"
From ATTWiki
| Line 42: | Line 42: | ||
<tr><td>Example +:</td><td>A value of +100 would double the speed of the Feed axis during draw bending.</td></tr> | <tr><td>Example +:</td><td>A value of +100 would double the speed of the Feed axis during draw bending.</td></tr> | ||
<tr><td>Example -:</td><td>A value of -100 would set the speed at 0 for the Feed axis during draw bending.</td></tr> | <tr><td>Example -:</td><td>A value of -100 would set the speed at 0 for the Feed axis during draw bending.</td></tr> | ||
| − | |||
| − | |||
<tr valign=top> | <tr valign=top> | ||
<td> | <td> | ||
| + | <br><br> | ||
The table at the right shows an example of a -10% change in the processlist: | The table at the right shows an example of a -10% change in the processlist: | ||
</td> | </td> | ||
Revision as of 13:06, 16 March 2010
|
|
|
Contents |
NEW - Feed Speed Percentage Adjustment for Feed Bend Mode
|
This new bend option allows you to fine-tune the calculated feed speed during Feed Bending.
|
|
| Value Type: | The value is entered as a floating point percentage. |
| + or -: | The value can be positive or negative. |
| Impact of Negative Values: | Negative values slow the calculated speed of the Feed axis. |
| Example +: | A value of +100 would double the speed of the Feed axis during draw bending. |
| Example -: | A value of -100 would set the speed at 0 for the Feed axis during draw bending. |
|
|
See vel0 calculated at 100%: |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
