Difference between revisions of "CNC Bender v12-20100611"
| Line 24: | Line 24: | ||
In the MANUAL page, the Direct Axis jog button must be active for external devices to control the jog. | In the MANUAL page, the Direct Axis jog button must be active for external devices to control the jog. | ||
<br><br> | <br><br> | ||
| − | In the CUSTOM COMMAND EDITOR page, the "TEACH MODE" must be active and an axis row selected for external devices to control the jog. | + | In the CUSTOM COMMAND EDITOR page, the "TEACH MODE" must be active and an axis row selected for external devices to control the jog.<br><br> |
| + | |||
| + | In the CUSTOM COMMAND EDITOR, the joystick and or teach-pendant controls both SERVO and DIRECTIONAL-VALVE actuators. This means that the joystick can also be used to close and open the chuck, clamps, and dies. | ||
</td> | </td> | ||
<td> | <td> | ||
Revision as of 15:00, 14 June 2010
|
|
NEW - CNC Bender Direct-Axis Jog with Joystick or Pendant
|
CNC Bender can now respond to a joystick or pendant buttons when direct-axis jogging.
In the CUSTOM COMMAND EDITOR, the joystick and or teach-pendant controls both SERVO and DIRECTIONAL-VALVE actuators. This means that the joystick can also be used to close and open the chuck, clamps, and dies. |
|
NEW- Setup Options for Direct Axis Jog from INPUTS
|
The low level general options list contains three new options:
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
