Difference between revisions of "Benderlink for FARO 1.5"
From ATTWiki
| Line 64: | Line 64: | ||
<tr> | <tr> | ||
<td width=150> | <td width=150> | ||
| − | Benderlink | + | Benderlink for FARO has extended Supravision network capabilities that the AddisonMckee Mark IV and Mark V controls make use of.</td> |
<td> | <td> | ||
| − | [[image: | + | [[image:addison_databend.jpg|300px]] |
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 23:39, 22 July 2010
New - Reverse Bend Data Features
|
There are times when the nominal tube data may show the opposite point and bend order than used for bending. During communications, the bend order needs to be the same - so this allows operators to adjust the order of the bend data to fit both the CAM2 measure and the bend data setup in the bender control. |
New - Automatically Reverse Incoming Data Checkbox
|
Benderlink can now automatically reverse all incoming FARO CAM2 data if this new feature is enabled. |
|
New - Reverse Bender Data or Un-reverse Bender Data
|
Benderlink can now reverse the FARO CAM2 data after it is imported. The Reverse Bend Data button acts as a toggle for reversing and un-reversing the bend data.
|
|
New - 64 Bit Compatibility
This Benderlink is now compatible with 64 bit Windows
New - Windows-based Help File
| Benderlink for FARO has extended Supravision network capabilities that the AddisonMckee Mark IV and Mark V controls make use of. |
|
New - Splash Screen
| Benderlink now includes a new splash screen. |
|
Other Pages
- Back to the Benderlink for FARO page
