Difference between revisions of "Benderlink for FARO 1.5"
From ATTWiki
| Line 59: | Line 59: | ||
<br><br> | <br><br> | ||
| − | ===[[image:Check.jpg|25px]] New - | + | ===[[image:Check.jpg|25px]] New - AddisonMckee Control Compatibility === |
<table> | <table> | ||
Revision as of 23:40, 22 July 2010
New - Reverse Bend Data Features
|
There are times when the nominal tube data may show the opposite point and bend order than used for bending. During communications, the bend order needs to be the same - so this allows operators to adjust the order of the bend data to fit both the CAM2 measure and the bend data setup in the bender control. |
New - Automatically Reverse Incoming Data Checkbox
|
Benderlink can now automatically reverse all incoming FARO CAM2 data if this new feature is enabled. |
|
New - Reverse Bender Data or Un-reverse Bender Data
|
Benderlink can now reverse the FARO CAM2 data after it is imported. The Reverse Bend Data button acts as a toggle for reversing and un-reversing the bend data.
|
|
New - 64 Bit Compatibility
This Benderlink is now compatible with 64 bit Windows
New - AddisonMckee Control Compatibility
| Benderlink for FARO now has extended Supravision network capabilities for AddisonMckee Mark IV and Mark V controls. |
|
New - Splash Screen
| Benderlink now includes a new splash screen. |
|
Other Pages
- Back to the Benderlink for FARO page
