Difference between revisions of "CNC Bender v12-20100903"
Line 17: | Line 17: | ||
<td width=200> | <td width=200> | ||
− | Now CNC Bender can CYCLE HOLD anywhere inside a custom command formed during setup or | + | Now CNC Bender can CYCLE HOLD anywhere inside a custom command formed during setup or in TEACH MODE.<br><br> |
+ | This allows operators to enter CYCLE HOLD virtually anywhere between bends during commands taught by the operator. | ||
<br><br> | <br><br> | ||
</td> | </td> |
Revision as of 00:03, 31 August 2010
NEW - CYCLE HOLD in Custom Commands and in TEACH Mode
Now CNC Bender can CYCLE HOLD anywhere inside a custom command formed during setup or in TEACH MODE. |
|
ENHANCED - ENABLE Button for STEP and AUTO Modes
The "REQUIRE ENABLE BUTTON" feature, when active, now also monitors for a switch to AUTO or STEP modes from MANUAL mode |
|
ENHANCED - Vertical Head Shift Tolerance Added
The vertical head shift tolerance allows us to skip motion when an axis is close enough to the final position. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands