Difference between revisions of "CNC Bender v12-20101005"
From ATTWiki
| Line 34: | Line 34: | ||
| − | ===[[image:Check.jpg|25px]] NEW - FEED AXIS DISPLAY FROM BACK OR FRONT === | + | ===[[image:Check.jpg|25px]] NEW - FEED AXIS POSITION DISPLAY FROM BACK OR FRONT === |
<table cellpadding=10> | <table cellpadding=10> | ||
Revision as of 13:42, 7 October 2010
|
|
Contents |
NEW - LOAD and START in RUN PAGE
|
The LOAD and START values can now be programmed in the RUN PAGE. |
|
NEW - FEED AXIS POSITION DISPLAY FROM BACK OR FRONT
|
The FEED axis values can be displayed from the front or the back by pressing a toggle button in the RUN PAGE. |
|
FIX - Load External Programs - Keyboard, CIO, COMDEF
| CNC Bender had lost the ability to load the keyboard, CIO Dictionary, and COMDEF dictionary. This was repaired on 9/7/2010 in this release. (Post release repair) |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
