Difference between revisions of "CNC Bender v12-20101021"
From ATTWiki
| Line 12: | Line 12: | ||
<br> | <br> | ||
| − | ===[[image:Check.jpg|25px]] NEW - | + | ===[[image:Check.jpg|25px]] NEW - Added Input Timer in PreEnable === |
<table cellpadding=10> | <table cellpadding=10> | ||
Revision as of 19:56, 22 October 2010
|
|
Contents |
NEW - Added Input Timer in PreEnable
|
This was added to allow for pulsing Lexium drives a specific amount of time before the axes were enabled. |
|
NEW - FEED AXIS POSITION DISPLAY FROM BACK OR FRONT
|
The FEED axis values can be displayed from the front or the back by pressing a toggle button in the RUN PAGE. |
|
NEW - FEED TORQUE ZEROED DURING MANDREL RETRACT
|
The FEED TORQUE is now set to ZERO% during mandrel retractions. This prevents possible destruction of the FEED gearbox, rack, pinion, chain, if the tube breaks during bending and the mandrel pulls the tube and carriage back. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
