Difference between revisions of "CNC Bender v12-20101116"
From ATTWiki
| Line 14: | Line 14: | ||
| − | ===[[image:Check.jpg|25px]] NEW - Absolute Rotate Delay === | + | ===[[image:Check.jpg|25px]] NEW - Absolute Pre-Rotate Delay === |
<table cellpadding=10> | <table cellpadding=10> | ||
| Line 27: | Line 27: | ||
</table> | </table> | ||
| − | |||
| − | |||
=Other Pages= | =Other Pages= | ||
Revision as of 17:08, 16 November 2010
|
|
Contents |
NEW - Absolute Pre-Rotate Delay
|
The absolute rotate command is highly optimized to rotate the spindle when the feed carriage is moving away from the part during the last bend. This programmed delay ensures that the chuck is off the part before rotating. (This is especially important for non-cylindrical tubes.) |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
