Difference between revisions of "CNC Bender v12-20110128"
From ATTWiki
| Line 36: | Line 36: | ||
Some benders don't need TEACH Mode, so the Teach Mode button can be made invisible by enabling a switch in the low level options list. | Some benders don't need TEACH Mode, so the Teach Mode button can be made invisible by enabling a switch in the low level options list. | ||
<br> | <br> | ||
| − | [[image: | + | [[image:teachbuttoninvisible_option.jpg|400px]] |
</td> | </td> | ||
<td> | <td> | ||
| − | [[image: | + | [[image:teachbuttoninvisible_button.jpg]] |
</td> | </td> | ||
Revision as of 22:48, 28 January 2011
v12-20110128
|
|
NEW - Process List Commands Can Ignore STEP Mode
|
Some commands don't move the actuators on bender. They only setup the bender. Now these commands can be told to not PAUSE during STEP MODE. This will reduce the number of run-button or foot-pedal steps required to run through a part on the bender in STEP mode.
|
|
ENHANCED - Teach Mode Button Can Be Invisible
|
Some benders don't need TEACH Mode, so the Teach Mode button can be made invisible by enabling a switch in the low level options list.
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
