Difference between revisions of "VTube-LASER v1.61"
From ATTWiki
Line 49: | Line 49: | ||
===[[image:Check.jpg|25px]] NEW: Automatically Set a ZERO Default Radius to 1.5 Times the Diameter=== | ===[[image:Check.jpg|25px]] NEW: Automatically Set a ZERO Default Radius to 1.5 Times the Diameter=== | ||
− | + | [[image:vtube-laser_automatic_default_radius_setup.jpg|500px]] | |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
If VTube discovers a default radius value of ZERO, then it will automatically reset the default radius to 1.5 times the nominal diameter before converting to the measured menu.<br><br> | If VTube discovers a default radius value of ZERO, then it will automatically reset the default radius to 1.5 times the nominal diameter before converting to the measured menu.<br><br> | ||
− | |||
</td> | </td> | ||
Revision as of 21:42, 4 March 2011
Revision 1.61Back to VTube-LASER |
NEW: Floating End Letters
Floating end letters can be switched on to help identify the ends A and B of the tube.
|
NEW: Can Automatically Expanded or Reduced End A and End B Diameter
If either End A or End B are set to a value of ZERO, then they will be automatically calculated based on the straight measurement adjacent to the end of the tube. |
NEW: Automatically Set a ZERO Default Radius to 1.5 Times the Diameter
If VTube discovers a default radius value of ZERO, then it will automatically reset the default radius to 1.5 times the nominal diameter before converting to the measured menu. |
Other Changes
|
Issues with this version fixed in next version
|
Other Pages
- Back to VTube-LASER