Difference between revisions of "CNC Bender v12-20110525"
From ATTWiki
| Line 23: | Line 23: | ||
<td width=400> | <td width=400> | ||
* Chuck Close/Open Skip in Post Bend - for special teach mode unloading<br><br> | * Chuck Close/Open Skip in Post Bend - for special teach mode unloading<br><br> | ||
| − | * Processor checks for special internal command | + | * Processor checks for special internal command in processlists - which is required even in custom processlists: '''[BEGIN RUN AGAIN]'''<br><br> |
| − | '''[BEGIN RUN AGAIN]''' | + | |
| − | + | ||
* Allow mandrel to advance in MANUAL page even if clamp or pressure die are closed. | * Allow mandrel to advance in MANUAL page even if clamp or pressure die are closed. | ||
</td> | </td> | ||
Revision as of 02:34, 26 May 2011
v12-20110525
|
|
ENHANCED - Changes
|
NEW - SmartInspect Configuration File Added
|
A new configuration file "loggingsetup.cfg" is added to the cnc\config folder.
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
