Difference between revisions of "CNC Bender v12-20110525"

From ATTWiki
Jump to: navigation, search
(→‎25px ENHANCED - Changes)
(→‎25px NEW - SmartInspect Configuration File Added)
Line 34: Line 34:
 
<br><br>
 
<br><br>
  
−
===[[image:Check.jpg|25px]] NEW - SmartInspect Configuration File Added  ===
 
  
−
<table cellpadding=10>
 
−
<tr valign=top>
 
−
<td width=400>
 
−
A new configuration file "loggingsetup.cfg" is added to the cnc\config folder.
 
−
<br><br>
 
−
The new logging setup allows for debug logging in both CNC Processor and CNC Bender.
 
−
<br><br>
 
−
The logging setup features for CNC Processor were previously in the CNCProcessor.cfg file.
 
−
</td>
 
−
 
−
<td>
 
−
[[image:logginsetup_file.jpg]]
 
−
</td>
 
−
 
−
</tr>
 
−
</table>
 
−
<br><br>
 
  
 
=Other Pages=
 
=Other Pages=

Revision as of 02:34, 26 May 2011

v12-20110525

Cncv12procontrol withteachmode.jpg



Check.jpg ENHANCED - Changes to Logic

  • Chuck Close/Open Skip in Post Bend - for special teach mode unloading

  • Processor checks for special internal command in processlists - which is required even in custom processlists: [BEGIN RUN AGAIN]

  • Allow mandrel to advance in MANUAL page even if clamp or pressure die are closed.




Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v12-20110525&oldid=16536"