Difference between revisions of "VTube-LASER v1.73"
From ATTWiki
| Line 89: | Line 89: | ||
<td width=300> | <td width=300> | ||
* A model memory leak was repaired. Project files no longer grow with every save - making loading and saving much faster in VTube. | * A model memory leak was repaired. Project files no longer grow with every save - making loading and saving much faster in VTube. | ||
| − | * The Split Bend logic was enhanced | + | * The Split Bend logic was enhanced and Split Bend envelopes were enhanced. |
| − | + | ||
* New confirmation menus for when pressing STOP or CLEAR the measure process. | * New confirmation menus for when pressing STOP or CLEAR the measure process. | ||
</td> | </td> | ||
Revision as of 23:36, 20 October 2011
|
Revision 1.73Back to VTube-LASER |
|
Contents |
ENHANCED: Fine Tune for FARO Edge ScanArm
|
The FARO Edge uses a different scan rate than the older arms. VTube-LASER was adjusted to work with the FARO Edge arms. |
ENHANCED: Cut Plane Offset Reset
|
The Cut Plane Offset can now be changed without remeasuring the Cut Plane.
|
ENHANCED: Cut Plane Offset Value
|
The Cut Plane Offset Value is now displayed above the Cut Plane icon.
|
NEW: Split Bend Model Display
|
New Split Bend model geometry is included on the screen when measuring split bends in order to visually verify the calculations.
|
NEW: XYZ INTERSECTION STRAIGHT LENGTHS
|
A new chart is included in the inspection report that shows the lengths between intersections for both the MASTER and MEASURED as well as the Delta between the two.
|
Other Changes
|
Issues with this version fixed in newer versions
|
Other Pages
- Back to VTube-LASER
|
VTube-LASER Training Video - How to perform effective end scans. |
|
