Difference between revisions of "CNC Bender v12-20111101"
From ATTWiki
| Line 25: | Line 25: | ||
</td> | </td> | ||
| − | <td> | + | <td width=300> |
The default value is "1" which means "true" or "enabled." Use 0 to switch this feature off. | The default value is "1" which means "true" or "enabled." Use 0 to switch this feature off. | ||
</td> | </td> | ||
| Line 32: | Line 32: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
===[[image:Check.jpg|25px]] NEW - "Enable Only To Move" in Axis List Setup === | ===[[image:Check.jpg|25px]] NEW - "Enable Only To Move" in Axis List Setup === | ||
Revision as of 02:20, 1 November 2011
v12-20111101
|
|
NEW - Pulse Enable At Halt in Axis List Setup
|
"Pulse Enable At Halt=" is a new parameter in the axis list configuration. This allows you to setup CNC Bender to always pulse the enable of an axis during the HALT command. This makes the axis super safe because it always clears all following error. |
The default value is "1" which means "true" or "enabled." Use 0 to switch this feature off. |
NEW - "Enable Only To Move" in Axis List Setup
|
"Enable Only To Move=" is a new parameter in the axis list configuration. This allows you to setup CNC Bender to enable axes only when in motion. |
The default value is "0" which means "disabled." Use 1 to switch this feature on. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
