Revision 1.75.1

Back to VTube-LASER
Back to VTube-STEP

VTube now shows the date, time, and page numbers at the bottom of print preview reports.

There were circumstances where VTube would backup too many steps during a remeasure. This has been repaired.

If the arm uses firmware version 702 or less, then it will display special messages when it is about to update the Scanner Control.

Follow these instructions if you change the Scanner Control setup from project to project.

The reason for this new step is that the Scanner Control will not update any integer values to or from VTube-LASER if the LASER is not able to be switched on during setup.

VTube now has a second set of tolerances for shorter straights. This allows for looser tolerances on shorter straights without producing an error message.

A new tolerance is added for surface point diameter check.

The current arm firmware is now read and used by VTube to determine how to handle the arm during Scanner Control changes.

For high-precision end scans, new end-scan techniques are recommended in the VTube-LASER manual.

• See End-Scan Using the Scissor Motion
• See End-Scan Using the End Wall
• See End-Scan Using End Targets

The VTube SVNET protocol now knows how to handle leftover communications files if they are present.

VTube can now save Supravision data to multiple file extension types: $$$, SV, or S2B