Difference between revisions of "End-Scan Technique Research"

Revision as of 23:58, 10 February 2012

End Scan Technique Research

Set System Options, Measure 2 Tab, "Maximum Number of LLP Points in String" to 3
Set Measure Setup - LASER Tab: The LASER defaults to ON for CYLINDERS and END-SCANS.
Set Measure Setup - LASER Tab: Cylinder stripes = 3 to 5
Set Measure Setup - LASER Tab: End-scan stripes = 5
Set Measure Setup - LASER Tab: Split bend stripes = 5
Set Measure Setup = Scan Rates Tab: Set all rates to TIMER for all scan types.
Set Measure Setup = Scan Rates Tab: Set the Scan Rates TIMER is set to 0 for all TIMERS.

@@ Line 45: / Line 45: @@
 </table>
-===How To Use This End-Scan Technique===
-<table cellpadding=10>
-<tr valign=top>
-<td width=300>
-* Align the scanner with a slight scissor angle across the end as is shown in the image on the right<br><br>
-* Attempt to hold the laser motionless when collecting the stripes across the end to increase repeatability.<br><br>
-* Consistently place the line across the same area of the tube end from measure to measure.<br><br>
-*Press the green button until VTube-LASER is finished scanning all the end stripes.<br><br>
-[[image:EndWithScissorCloseup.jpg|300px]]<br><br>
-</td>
-<td width=300>
-[[image:EndWithScissor.jpg|300px]]
-</td>
-</tr>
-</table>
 ===Other Pages===