Difference between revisions of "CNC Bender v12-20120728"
From ATTWiki
| Line 36: | Line 36: | ||
<td width=400> | <td width=400> | ||
When this label was encountered in the Processor, any error would be reported in all cases. This has no value - so it is now ignored completely. | When this label was encountered in the Processor, any error would be reported in all cases. This has no value - so it is now ignored completely. | ||
| − | |||
| − | |||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
</td> | </td> | ||
| − | |||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
| − | |||
=== [[image:Check.jpg|25px]] Build a File Filled with Cut Lengths from All Part Files in a Folder=== | === [[image:Check.jpg|25px]] Build a File Filled with Cut Lengths from All Part Files in a Folder=== | ||
Revision as of 00:12, 7 August 2012
v12-20120728
|
|
Enhanced HALT in Processor for Servo Motion
|
This version implements a stronger HALT in CNC Processor to be sure motion commands are halted during E-Stop. This will ensure that Processor does not continue to move the bender during an E-Stop type event.
|
Ceased Reporting Error for [BEGIN PROGRAM] Label
|
When this label was encountered in the Processor, any error would be reported in all cases. This has no value - so it is now ignored completely. |
Build a File Filled with Cut Lengths from All Part Files in a Folder
|
This CNC Bender utility program can extract the cut lengths from all the part files in a parts folder in batch mode. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
