Difference between revisions of "CNC Bender v12-20120728"
From ATTWiki
| Line 43: | Line 43: | ||
</table> | </table> | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
=Other Pages= | =Other Pages= | ||
Revision as of 00:14, 7 August 2012
v12-20120728
|
|
Enhanced HALT in Processor for Servo Motion
|
This version implements a stronger HALT in CNC Processor to be sure motion commands are halted during E-Stop. This will ensure that Processor does not continue to move the bender during an E-Stop type event.
|
Ceased Reporting Error for [BEGIN PROGRAM] Label
|
When this label was encountered in the Processor, any error would be reported in all cases. This has no value - so it is now ignored completely. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
