Difference between revisions of "VTube-STEP v1.77.3"
From ATTWiki
| Line 19: | Line 19: | ||
===[[image:Check.jpg|25px]] UPDATED: View Orientation Control=== | ===[[image:Check.jpg|25px]] UPDATED: View Orientation Control=== | ||
| − | [[image:vtube_1.77.3_vieworientation_closeup.jpg| | + | [[image:vtube_1.77.3_vieworientation_closeup.jpg|250px]] |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
Revision as of 03:18, 8 August 2012
|
Revision 1.77.3
|
|
UPDATED: View Orientation Control
|
The View Orientation Control has new choices with graphics icons of each axes orientation. |
|
NEW: End Lengths Change in Diameter Model with End Adjustment Length Values
| When the A-End or B-End Adjustment Lengths change, then the diameter model lengths change automatically at the next redraw. This does not change the centerline end point location. |
REPAIR: Cut Length Calculation with End Adjustments
| The End Length Adjustments were doubled in the Cut Length calculation. This is repaired in this version. |
Other Pages
- Back to the VTube page
