Difference between revisions of "VTube-STEP v1.77.3"
From ATTWiki
| Line 32: | Line 32: | ||
===[[image:Check.jpg|25px]] NEW: End Lengths Change in Diameter Model with End Adjustment Length Values=== | ===[[image:Check.jpg|25px]] NEW: End Lengths Change in Diameter Model with End Adjustment Length Values=== | ||
| − | [[image:vtube_1.77.3_EndLengthShortened_Closeup.jpg | + | [[image:vtube_1.77.3_EndLengthShortened_Closeup.jpg]] |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
| Line 42: | Line 42: | ||
</table> | </table> | ||
[[image:vtube_1.77.3_EndLengthShortened.jpg|500px]] | [[image:vtube_1.77.3_EndLengthShortened.jpg|500px]] | ||
| + | <br><br> | ||
===[[image:Check.jpg|25px]] REPAIR: Cut Length Calculation with End Adjustments=== | ===[[image:Check.jpg|25px]] REPAIR: Cut Length Calculation with End Adjustments=== | ||
Revision as of 03:20, 8 August 2012
|
Revision 1.77.3
|
|
UPDATED: View Orientation Control
|
The View Orientation Control has new choices with graphics icons of each axes orientation. |
NEW: End Lengths Change in Diameter Model with End Adjustment Length Values
| When the A-End or B-End Adjustment Lengths change, then the diameter model lengths change automatically at the next redraw. This does not change the centerline end point location. |
REPAIR: Cut Length Calculation with End Adjustments
| The End Length Adjustments were doubled in the Cut Length calculation. This is repaired in this version. |
Other Pages
- Back to the VTube page
