Difference between revisions of "VTube-STEP v1.77.3"
From ATTWiki
| Line 44: | Line 44: | ||
<br><br> | <br><br> | ||
| − | ===[[image:Check.jpg|25px]] REPAIR: The Cut Length Calculation with End Adjustments Is Repaired=== | + | ===[[image:Check.jpg|25px]] REPAIR: The Cut Length Calculation with Non Zero End Adjustments Is Repaired=== |
[[image:vtube_endlength_cutlength_partsetup.jpg|300px]] | [[image:vtube_endlength_cutlength_partsetup.jpg|300px]] | ||
<table cellpadding=10> | <table cellpadding=10> | ||
Latest revision as of 03:26, 8 August 2012
|
Revision 1.77.3
|
|
ENHANCED: View Orientation Control Redesigned
|
|
|
NEW: Diameter Model End Lengths Change Based on New "End Adjustment Length" Values in Part Setup
| When the A-End or B-End Adjustment Lengths change, then the diameter model lengths change automatically at the next redraw. This does not change the centerline end point location. |
REPAIR: The Cut Length Calculation with Non Zero End Adjustments Is Repaired
| The End Length Adjustments values are no longer doubled in the Cut Length calculation. |
Other Pages
- Back to the VTube page
