Difference between revisions of "Benderlink for SolidWorks"
From ATTWiki
| Line 1: | Line 1: | ||
| − | Benderlink for Solid Works software is designed to convert from Solid Works to bender data then to connect Solid Works workstations to SVNET-based benders. | + | Benderlink for Solid Works software is designed to '''convert''' from Solid Works to bender data then to '''connect''' Solid Works workstations to SVNET-based benders. |
| − | If a measuring center arm is setup to sketch a 3D centerline of a measured tube shape, then Benderlink will help you reverse-engineer tube shapes, and assist in correcting the bender's data. | + | If a '''measuring center''' arm is setup to sketch a 3D centerline of a measured tube shape, then Benderlink will help you '''reverse-engineer''' tube shapes, and assist in '''correcting''' the bender's data. |
http://advancedtubular.com/blink_sw/help_html/clip0003.jpg | http://advancedtubular.com/blink_sw/help_html/clip0003.jpg | ||
Revision as of 22:22, 28 July 2006
Benderlink for Solid Works software is designed to convert from Solid Works to bender data then to connect Solid Works workstations to SVNET-based benders.
If a measuring center arm is setup to sketch a 3D centerline of a measured tube shape, then Benderlink will help you reverse-engineer tube shapes, and assist in correcting the bender's data.
http://advancedtubular.com/blink_sw/help_html/clip0003.jpg
Features
The main features of this software:
- - Read tube data from Solid Works
- - Convert the tube data to bender data
- - Save / Recall the bender data
- - Send new nominal data to benders that support SVNET protocol.
- - Make and send correction data to benders that support the SVNET protocol.
The correction feature is peformed by measuring a tube with ROMER / FARO arm, using this data to create a tube centerline in Solid Works, then allow Benderlink to compare this inspected data with the MASTER data.
[1] Read the online help
--Mcone 13:37, 28 July 2006 (EDT)
