Difference between revisions of "CNC Bender v12-20120830"
From ATTWiki
| Line 35: | Line 35: | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
===[[image:Check.jpg|25px]] Ceased Reporting Error for [BEGIN PROGRAM] Label=== | ===[[image:Check.jpg|25px]] Ceased Reporting Error for [BEGIN PROGRAM] Label=== | ||
Revision as of 11:14, 30 August 2012
v12-20120830
|
|
Enhanced: Autoloader Manual Page Redesign
CNC Bender can now make the TUBE ROTATE and SEAM DETECT buttons invisible. See these two screens:
This next screen shows the two buttons removed from the screen:
|
Control the visibility of buttons with new low level options:
|
Ceased Reporting Error for [BEGIN PROGRAM] Label
|
When this label was encountered in the Processor, any error would be reported in all cases. This has no value - so it is now ignored completely. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
