Difference between revisions of "How to Switch the OD Mesh On/Off"
(→Step 3: Start the DXF File Import Feature) |
(→Step 4: Organize the Layout) |
||
| Line 71: | Line 71: | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
== Step 5: Set the Diameter == | == Step 5: Set the Diameter == | ||
Revision as of 14:50, 8 September 2012
Contents |
Entities Described
The OD Mesh can be composed of two types of entities - either WIRE or SURFACE. Either can be switched on or off independently in TubeCAD. This page describes ways to control them.
Switch Straights Wire
|
Switch the straights WIRE mesh off in the straights by using the Primary Views>3D>Straights wire>On/Off |
|
Switch Arcs Wire
|
Switch the arcs WIRE mesh off in the straights by using the Primary Views>3D>Arcs wire>On/Off |
|
Switch Straights Faces
|
Switch the straights surface mesh off in the straights by using the Primary Views>3D>Straights faces>On/Off |
|
Switch Arcs Wire
|
Switch the arcs surface mesh off in the straights by using the Primary Views>3D>Arcs faces>On/Off |
|
Switch Between Surface and Outline Quickly
|
You can switch between surface and outline display quickly by pressing on the right toolbar button with the surface mesh. |
|
Step 5: Set the Diameter
|
The incoming data will not contain a diameter, so you can set that value in the General Spec menu.
|
|
|
The image will display something like this: |
|
Step 6: Zoom Extents
|
Zoom to the extents to see the entire layout.
|
|
Other Pages
Go back to TubeCAD Pro
