Difference between revisions of "Cable Spec 33"
From ATTWiki
| Line 12: | Line 12: | ||
<br> | <br> | ||
<br> | <br> | ||
| − | In this configuration, it is necessary to use a version 2 CB-EL1 board with the jumpers set to "BND" to simulate the bender side of the connection. Use this setup for connecting a non Eaton Leonard bender to an Eaton Leonard Vector measuring center.<br> | + | |
| − | [[image:cb-el1_bendermode.jpg]] | + | ==CB-EL1 Board Setup== |
| + | In this configuration, it is necessary to use a version 2 CB-EL1 board with the jumpers set to "BND" to simulate the bender side of the connection. Use this setup for connecting a non Eaton Leonard bender to an Eaton Leonard Vector measuring center.<br><br> | ||
| + | The original CB-EL1 board could only handle the Vector measuring center side connection. Do not use v1 in this configuration.<br><br> | ||
| + | [[image:cb-el1_bendermode.jpg|800px]] | ||
Revision as of 20:58, 17 September 2012
For use inside Benderlink Ethernet Modules with current loop electronics.
Use for simulating the PREMIER (Bender) side only.
Wiring schematic:
CB-EL1 Board Setup
In this configuration, it is necessary to use a version 2 CB-EL1 board with the jumpers set to "BND" to simulate the bender side of the connection. Use this setup for connecting a non Eaton Leonard bender to an Eaton Leonard Vector measuring center.
The original CB-EL1 board could only handle the Vector measuring center side connection. Do not use v1 in this configuration.
