Difference between revisions of "Cable Spec 33"
From ATTWiki
| Line 13: | Line 13: | ||
<br> | <br> | ||
| − | ==CB-EL1 Board Setup== | + | ==CB-EL1 Board Setup For Use With Cable 33== |
In this configuration, it is necessary to use a version 2 CB-EL1 board with the jumpers set to "BND" to simulate the bender side of the connection. Use this setup for connecting a non Eaton Leonard bender to an Eaton Leonard Vector measuring center.<br><br> | In this configuration, it is necessary to use a version 2 CB-EL1 board with the jumpers set to "BND" to simulate the bender side of the connection. Use this setup for connecting a non Eaton Leonard bender to an Eaton Leonard Vector measuring center.<br><br> | ||
The original CB-EL1 board could only handle the Vector measuring center side connection. Do not use v1 in this configuration.<br><br> | The original CB-EL1 board could only handle the Vector measuring center side connection. Do not use v1 in this configuration.<br><br> | ||
Revision as of 21:00, 17 September 2012
For use inside Benderlink Ethernet Modules with current loop electronics.
Use for simulating the PREMIER (Bender) side only.
Wiring schematic:
CB-EL1 Board Setup For Use With Cable 33
In this configuration, it is necessary to use a version 2 CB-EL1 board with the jumpers set to "BND" to simulate the bender side of the connection. Use this setup for connecting a non Eaton Leonard bender to an Eaton Leonard Vector measuring center.
The original CB-EL1 board could only handle the Vector measuring center side connection. Do not use v1 in this configuration.
