Difference between revisions of "Output Sustain in Seconds"
From ATTWiki
| Line 1: | Line 1: | ||
| + | [[Image:Cnclite lowlevel processor.jpg|frame|right]] | ||
| + | |||
| + | |||
This is a LOW LEVEL variable in CNC Bender that allows you to set the sustain time for the output module that keeps the bender running.<p> | This is a LOW LEVEL variable in CNC Bender that allows you to set the sustain time for the output module that keeps the bender running.<p> | ||
The default value is 10 seconds. But in some cases, it may be necessary to set this value higher if other processes require too much CPU time to service this output module within 10 seconds. This may be the situation when building a very large process list in CNC Bender Lite software while the bender is running. | The default value is 10 seconds. But in some cases, it may be necessary to set this value higher if other processes require too much CPU time to service this output module within 10 seconds. This may be the situation when building a very large process list in CNC Bender Lite software while the bender is running. | ||
</p> | </p> | ||
| + | |||
| + | |||
| + | |||
===Advanced Optimization Ideas=== | ===Advanced Optimization Ideas=== | ||
Revision as of 19:44, 11 January 2007
The default value is 10 seconds. But in some cases, it may be necessary to set this value higher if other processes require too much CPU time to service this output module within 10 seconds. This may be the situation when building a very large process list in CNC Bender Lite software while the bender is running.
Advanced Optimization Ideas
|
Be sure all axes are tuned properly. |
image:Cnclite lowlevel processor.jpg |
|
Be sure all axes and actuators are travelling at maximum sustainable speed. |
|
See also Bend Program Optimization
--Mcone 10:32, 20 July 2006 (EDT)
