Difference between revisions of "VTube-LASER v1.82.1"

Revision 1.82.1

• Back to VTube-STEP
• Back to VTube Software Updates (for LASER Mode)
• Back to VTube-LASER

The user interface can adjust the font sizes to fit more data on the screen.

Bender Setup now shows the most recent event times for the project in memory.

This includes the time of the most recent recall from the bender, the time of the most recent send to the bender, and the time of the most recent adjustment data calculation.

These two changes are made to bender corrections:

Better Adjustment Calculation Handling

• Previous versions would always recalculate the LRA adjustment values when loading the Bender Setup menu. This was problem because the LRA adjustment values could never be manually adjusted or cleared by the user. Now the adjustment values are calculated only when a new measured tube is created.
  
  
• The adjustment values in the Bender Setup screen are now stored in the project files. This means that the values will be retained between sessions. You can clear the adjustments, and they will stay zeroed until a new measured tube is created.

New "Copy Master Part Setup Values" Button

This button allows you to update just the part setup values in Bender Setup without changing the LRA bender data.

The new interface uses a blue gradient background for a better viewing experience.

• Overbend Calculator is now integrated into VTube. The values are now always updated and transferred back to VTube as they are entered in the Overbend.
  
  
• Fixed default radius bug for single straight tubes.
  
  
• Repaired the End Label delete when tube is cleared. (The End Labels did not always clear from the screen when the tubes were cleared or turned off.)