Difference between revisions of "CNC Bender v12.1.1"
From ATTWiki
(→25px FIX: CNC Bender Benderlink Fix with Laservision) |
(→25px ENHANCED: CNC Bender Benderlink Can Emulated Hyprex Laservision) |
||
| Line 27: | Line 27: | ||
CNC Bender Benderlink would sometimes return an out-of-bounds error after receiving Laservision data. This was related to setting the first straight adjustment value to zero. It has been resolved. | CNC Bender Benderlink would sometimes return an out-of-bounds error after receiving Laservision data. This was related to setting the first straight adjustment value to zero. It has been resolved. | ||
| − | + | ==[[image:Check.jpg|25px]] ENHANCED: CNC Bender Benderlink Can Emulated Hyprex Laservision== | |
Hyprex Laservision | Hyprex Laservision | ||
Revision as of 15:56, 14 August 2013
v12.1 - August 14, 2013
|
|
FIX: FRB Clear Part Fixed
CNC Bender would save parts after a FRB clear by default in the c:\cnc\config folder. This was repaired so that it saves inside the the correct parts folder.
NEW: Processor Now Checks to See if Inputs are Internal
CNC Processor can now check if an input is an internal input that is not connected to a physical input. This is used for setting and reading states inside the Processor without using actual physical I/O.
FIX: CNC Bender Benderlink Fix with Laservision
CNC Bender Benderlink would sometimes return an out-of-bounds error after receiving Laservision data. This was related to setting the first straight adjustment value to zero. It has been resolved.
ENHANCED: CNC Bender Benderlink Can Emulated Hyprex Laservision
Hyprex Laservision
Other Changes
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
