Difference between revisions of "Revision: Benderlink for Chiyoda/Keins 6.7"

Revision as of 23:32, 8 November 2013

ENHANCED - New COM Engine Choice

This Benderlink can use either the new WinSoft COM engine for faster communications, or the older MarshallSoft engine for cases where the older engine works better.

The Benderlink.ini file is found in the c:\Users\[username]\AppData\Roaming\BenderlinkChiyodaKeins folder.

Edit the Benderlink.ini in a notepad editor. The line to change is

[Communications Setup]
COM Engine=WinSoft

The COM Engine line can be set to WinSoft or Marshallsoft. (The case is not important.)

ENHANCED - New CONVERSION Menu Option

Benderlink can now ignore radii values of zero by unchecking the option in the main conversion window.

If the zero diameter is ignored, then Benderlink will automatically set the diameter to non-zero using the Rad Level 1 / 1.5 formula.

If the Rad Level 1 value is zero, then Benderlink will use the Rad Level 2 value. If both are zero, then Benderlink will set the diameter to 1 unit.

A non-zero diameter is important for when you communicating with ROMER DOCS software because DOCS will report a corrupted file if it senses a zero radius. (This is not an issue in VTube-LASER - it can ignore the diameter of zero.)

OTHER PAGES

• Back to Benderlink for KEINS
• Back to Benderlink for Chiyoda
• Benderlink for Chiyoda FAQ
• About Chiyoda - See this page for control version information.