Difference between revisions of "VTube-STEP v1.84"

Revision 1.84

• Back to VTube-STEP
• Back to VTube-STEP Revisions
• Back to VTube Software Updates (for LASER Mode)
• Back to VTube-LASER

VTube can now export XYZ data to an Alpine M4 data file. This feature sends XYZ coordinates for setup.



The extended export feature lets you set the radius level before sending the data to the bender.

The SolidWorks tube builder can now:

• Build constrained end and intersection points in 3DSketch.
  
  
• Build constrained centerline geometry in 3DSketch.
  
  

The side menus can be collapsed and expanded very quickly in order to show you an expanded viewport.

Use the blue arrows at the corner of either the left or right panels to collapse the menus. Move the mouse over the collapsed menu to expand them.

Compare these two images. The top screen shows the left panel collapsed. The bottom screen shows the same window with the left panel expanded.

The side menu fonts can be changed in System Options to fit more or less on the screen vertically.

The side menu widths can be set to default to NARROW, MEDIUM, or WIDE in the System Option menu.

This free-form editor allows you to enter comments 1 and 2 as notes with empty rows using the Enter button.

You can even load and save external text files to and from the Comment fields.

The Supravision export would use the A-End and B-End Solid Model Offset for the Supravision end offsets in the exported Supravision file. The values that should be used are the A-End and B-End Length Adjust - because that is the equivalent for Supravision end offsets.

This has been repaired in this version.

The new Close button allows you to close VTube more quickly than before.

The new Save As button allows you to save the current part as a new part file.

VTube now includes a TubeCalc Elongation Converter that can be accessed from the Part Setup popup menu. This converter calculates VTube elongation percentages from TubeCalc elongation per degree values.

The new chart shows absolute LENGTHS and ROTATIONS appropriate for Conrac style benders.

This chart always uses arc lengths that are compensated for elongation based on the elongation percentage in the part setup menu.

• VTube now always reports reduced arc lengths compensated for elongation if the elongation percentage is greater than 0. (It used to always report the theoretical value without elongation.)
  
  

• VTube no longer refreshes the tube model on the screen when a project is saved. This saves significant amount of time for large models.
  
  

• The model refresh time is optimized significantly - especially when the point labels are switched on.
  
  

• Repairs were made to the Language Editor.
  
  

• Internal were made repairs to the Part Setup grid. Corrections were made to field types.
  
  

• Click on column cell 1 of the Default Radius field to show the Radius Table.