Difference between revisions of "Overbend Calculator"

Revision as of 02:58, 14 April 2014

Reduce Scrap & Save Material by Predicting Springback BEFORE Bending the Part

This is software that calculates overbend necessary to overcome springback in bends.

STEP 1: Two test bends are made. Typically they are 20 and 120 degrees. The bender is set to bend these angles and a test tube is bent.

STEP 2: The actual resulting bend angles are measured and entered into the overbend calculator.

STEP 3: Formula constant values are calculated and used in a springback formula to predict overbend to overcome springback at any angle.

The Overbend Calculator is also embedded in VTube-STEP and VTube-LASER because the fixed and proportional springback values are included in the Part Setup menu - and have an effect on sending especially new data to the bender. To access the calculator inside VTube, follow these steps:
STEP 1: Right click anywhere in the white column in the Part Setup menu.
STEP 2: Choose "Show Overbend Calculator" in the context menu (the popup menu).
STEP 3: Make a part with two test bends. Typically they are 20 and 120 degrees. The bender is set to bend these angles and a test tube is bent.
STEP 4: The actual resulting bend angles are measured and entered into the overbend calculator.
STEP 5: Formula constant values are calculated and used in a springback formula to predict overbend to overcome springback at any angle.
STEP 6: Press the "Save to Part Setup" button. The values will now be displayed at the bottom of the Part Setup menu.
They will be used to calculate overbend to overcome springback when sending data to the bender. This image shows a button inside the Bender Setup menu in VTube-LASER.

Screen Shot	Date Released	Link to Page	New Features
	October 13, 2009	Overbend Calculator v7.1	New - Simplified Shareware Licensing
	April 6, 2009	Overbend Calculator v7	New - Grid display of data New - Eaton Leonard style value constants also calculated New - Shareware licensing

@@ Line 37: / Line 37: @@
 <tr>
 <td width=300>
-The fixed and proportional springback values are included in the Part Setup menu - and have an effect on sending especially new data to the bender.  Because of this, the Overbend Calculator is embedded in VTube-STEP and VTube-LASER.  To access the calculator inside VTube, follow these steps:
+The Overbend Calculator is also embedded in [[VTube-STEP]] and [[VTube-LASER]] because the fixed and proportional springback values are included in the Part Setup menu - and have an effect on sending especially new data to the bender.<br><br>
+To access the calculator inside VTube, follow these steps:
 </td>
 <td>