Difference between revisions of "VTube End Length Offsets"
From ATTWiki
(→End Offsets) |
(→How End Offsets Work in VTube) |
||
| Line 18: | Line 18: | ||
| − | ==How End Offsets Work in VTube== | + | ==How End LENGTH Offsets Work in VTube== |
<table cellpadding=10> | <table cellpadding=10> | ||
Revision as of 02:06, 24 April 2014
|
|
|
Contents |
How End LENGTH Offsets Work in VTube
End Offsets Add or Subtract Material LengthThe end offsets in the Part Setup menu control the end lengths in real-time.
|
|
Entering Offsets in the Part Setup MenuWe can change the B End Offset in the Part Setup menu like this: |
|
Using Transparency to Show the EffectHere is the result with transparency increased to 0.75: |
|
Other Pages
- Back to VTube-LASER
