Difference between revisions of "VTube End Length Offsets"
From ATTWiki
(→Entering a Negative Length Offset in the Part Setup Menu) |
|||
| Line 15: | Line 15: | ||
<br> | <br> | ||
| − | + | ||
| + | * It is possible to use end length adjustments to adjust the material length of the tube without moving the actual end point.<br><br> | ||
| + | * Use this to add material for end forms and other operations that require extra material.<br><br> | ||
| + | * These offsets will be added into the calculated Cut Length in the Part Setup menu.<br><br> | ||
Revision as of 02:15, 24 April 2014
|
|
|
- It is possible to use end length adjustments to adjust the material length of the tube without moving the actual end point.
- Use this to add material for end forms and other operations that require extra material.
- These offsets will be added into the calculated Cut Length in the Part Setup menu.
Contents |
How End LENGTH Offsets Work in VTube
End Length Offsets Add or Subtract Material LengthThe end offsets in the Part Setup menu add or subtract material the ends in real-time.
|
|
Entering a Positive Length Offset in the Part Setup MenuWe can change the B End Offset in the Part Setup menu like this: |
|
Using Transparency to Show the EffectHere is the result with transparency increased to 0.75: |
|
Entering a Negative Length Offset in the Part Setup MenuYou can also subtract material from an end by using a negative value like this: |
|
Other Pages
- Back to VTube-LASER
