Difference between revisions of "CNC Bender v14.9"

Revision as of 15:04, 2 September 2015

New automatic mandrel support is added to CNC Processor.

Command Name - Mandrel Support Up: This is the COMDEF name for sending the mandrel support UP. CNC Bender uses this in the manual page.
Command Name - Mandrel Support Down: This is the COMDEF name for sending the mandrel support DOWN. CNC Bender uses this in the manual page.
CIO Name - Mandrel Support Output Down: This is the CIO output for sending the mandrel support down. CNC Processor uses this to send the Mandrel support down automatically.
CIO Name - Mandrel Support Output Up: This is the CIO output for sending the mandrel support up. CNC Processor uses this to send the Mandrel support up automatically.
CIO Name - Mandrel Support Input Down: This is the CIO input for checking if the mandrel support is down. CNC Processor uses this, if present, to stop the AUTO process if the Mandrel support does not signals down when it should.
Mandrel Support Input Check Pause Timer - This is a millisecond pause timer that pauses before checking for the mandrel down input active. The maximum value is 1000 milliseconds.
Mandrel Support Buttons Hide - This allows you to hide the manual page buttons in CNC Bender.

@@ Line 31: / Line 31: @@
 <br>
-==[[image:Check.jpg|25px]] ENHANCED: TEST BEND Pressure Die Motion ==
+==[[image:Check.jpg|25px]] ENHANCED: Manual Page Die Motion Interlocks Changed ==
-<table>
+*Interlock removed: The Pressure Die Timer interlocks are removed.<br><br>
-<tr valign=top>
-<td width=300>
+*Interlock removed: Clamp can now open if Extra Clamp present and PD not open<br><br>
-The Pressure Die open and close in the TEST BEND page can now be used even no matter where the CLAMP die is.<br><br>
-</td>
+*Interlock removed: The clamp can now close before the PD closes<br><br>
-<td width=500>
-</td>
+*Interlock removed: The extra clamp to open regardless of where the PD is.<br>
-</tr>
-</table>
-<br>
 ==Other Pages==