Difference between revisions of "Feed-Bend Motion Adjust Percent"
| Line 1: | Line 1: | ||
[[image: feed-bend_motion_adjust_multiple_radii.jpg|450px]] | [[image: feed-bend_motion_adjust_multiple_radii.jpg|450px]] | ||
| − | This | + | This [[Dynamic Option]] allows for adjusting the Feed/Carriage motion during Feed-Bending for all bend radius levels. |
This allows for elongation during bending and prevents bowing or stretching of the material. The features are options are in the [[Overall Bending Options]] menu of the [[BENDING Menu]]. | This allows for elongation during bending and prevents bowing or stretching of the material. The features are options are in the [[Overall Bending Options]] menu of the [[BENDING Menu]]. | ||
Revision as of 17:15, 3 April 2007
This Dynamic Option allows for adjusting the Feed/Carriage motion during Feed-Bending for all bend radius levels.
This allows for elongation during bending and prevents bowing or stretching of the material. The features are options are in the Overall Bending Options menu of the BENDING Menu.
|
Feed-Bend Motion Adjust % Floating Point Value |
|
|
Using a Value of ZERO |
A value of ZERO will cause no adjustment in the Feed motion during Feed Bending. |
|
Using a Value BELOW ZERO |
For example, enter -5 (negative 5) to adjust the Feed motion during Feed bending by negative 5 percent. Use this value will accomodate for...
Decreasing the value too much will likely cause the tube to pull from the chuck. |
|
Using a Value of ABOVE ZERO |
For example, enter 5 (positive 5) to move 5 percent further during Feed Bending.. Increasing the value too much will cause the Feed to attempt to press further for final position, not allowing it to come into position. |
