Difference between revisions of "CNC Bender v10-20070702"
(→NEW: Splash / Version Screen Shows License Type) |
(→NEW: Splash / Version Screen Shows License Type) |
||
| Line 24: | Line 24: | ||
[[Image:cncbender_v10-20070702_splash_procontrol_full.jpg|200px]] | [[Image:cncbender_v10-20070702_splash_procontrol_full.jpg|200px]] | ||
[[Image:cncbender_v10-20070702_splash_procontrol_offline.jpg|200px]] | [[Image:cncbender_v10-20070702_splash_procontrol_offline.jpg|200px]] | ||
| − | |||
Revision as of 20:38, 2 July 2007
Contents |
REVISION Information
10-20070707, July 2, 2007
NEW: LiteControl GUI Update
The LiteControl now features the same updated GUI as the ProControl. It also requires the the higher screen resolution of 1024 x 768. (The older 800 x 600 is too low for the new software.)
NEW: Splash / Version Screen Shows License Type
CNC Bender can use one of four license models:
- ProControl Full
- ProControl Offline
- LiteControl Full
- LiteControl Offline
During startup or display of the version screen, the license type is displayed. For example, this shows the OFFLINE license type is running:
ENHANCED: Hardware Key Handling
There are new rules requiring hardware key setup for CNC Bender:
|
REQUIRED PROGRAM ID |
Hardware keys used for CNC Bender now require an appropriate program ID in both the time-limited and the permanent hardware key. |
|
LiteCONTROL - |
LiteControl licenses are now linked to a single specific hardware key. The setup of every PERMANENT KEYED LiteControl configuration file must be performed by Advanced Tubular before CNC Bender LiteControl will run. |
|
ProCONTROL - |
ProControl licenses are NOT linked to a specific hardware key, but the hardware key must contain a general ProControl license. |
|
TIME KEYS |
Neither LiteControl or ProControl licenses are linked to to a single hardware key. However, the hardware key must contain a setup for at least one of the four license types (see the previous topic). |
ENHANCED: NEW Option: CYCLE HOLD after POST-BEND JOG
The BEND OPTION cells contain a new CYCLE HOLD option that allows for tool clearance immediately after a Post-Bend jog.
