Difference between revisions of "CNC Bender v15.1"
From ATTWiki
(→25px NEW: Tube Support 2 Added) |
(→25px NEW: Tube Support 2 Added) |
||
| Line 20: | Line 20: | ||
<table width=1000> | <table width=1000> | ||
<tr> | <tr> | ||
| − | <td width= | + | <td width=300> |
| − | We added to CNC Processor the | + | We added to CNC Processor the ability to raise and lower a second Tube Support for Feed axis motion on extra long benders. |
| − | + | There are now three supports that can be active at the same time: | |
* Tube Support 1 (in front of the carriage) | * Tube Support 1 (in front of the carriage) | ||
Revision as of 02:28, 27 February 2017
v15.1 - February 25, 2017
|
|
NEW: Tube Support 2 Added
|
We added to CNC Processor the ability to raise and lower a second Tube Support for Feed axis motion on extra long benders. There are now three supports that can be active at the same time:
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
