Difference between revisions of "Safe Mode Motion Auto Recovery"
| Line 1: | Line 1: | ||
| − | + | _toc_ | |
| + | ==Basic Description== | ||
CNC Bender motion can recover and complete any controlled motion from any "[[Safe Mode Cycle Hold]]" state to a [[Cycle Start]] condition.<br><br> | CNC Bender motion can recover and complete any controlled motion from any "[[Safe Mode Cycle Hold]]" state to a [[Cycle Start]] condition.<br><br> | ||
This includes [[Auto Mode]] motion, [[Step Mode]] motion, and [[Controlled Jog]] motion.<br><br> | This includes [[Auto Mode]] motion, [[Step Mode]] motion, and [[Controlled Jog]] motion.<br><br> | ||
| + | ==How It Works== | ||
If an operator steps on the mat in the middle of any motion, the SMT bender comes to a zero-energy state immediately. All axes are disabled. When the operator presses [[Cycle Start]], then the bender will recover from the disabled state, re-enable the axes, calculate the remaining motion, and then complete all motion. <br><br> | If an operator steps on the mat in the middle of any motion, the SMT bender comes to a zero-energy state immediately. All axes are disabled. When the operator presses [[Cycle Start]], then the bender will recover from the disabled state, re-enable the axes, calculate the remaining motion, and then complete all motion. <br><br> | ||
| − | This is true of the primary and all secondary | + | ==All [[Processlist]] Types== |
| + | This is true of the primary and all secondary [[processlist]]s running at the same time.<br><br> | ||
| + | |||
| + | |||
| + | ''Note: This feature is available on CNC Bender software versions 10-20070425 and higher. The feature is available for installation on older systems, but requires that the older system electronics be upgraded.'' | ||
Revision as of 22:07, 12 July 2007
_toc_
Basic Description
CNC Bender motion can recover and complete any controlled motion from any "Safe Mode Cycle Hold" state to a Cycle Start condition.
This includes Auto Mode motion, Step Mode motion, and Controlled Jog motion.
How It Works
If an operator steps on the mat in the middle of any motion, the SMT bender comes to a zero-energy state immediately. All axes are disabled. When the operator presses Cycle Start, then the bender will recover from the disabled state, re-enable the axes, calculate the remaining motion, and then complete all motion.
All Processlist Types
This is true of the primary and all secondary processlists running at the same time.
Note: This feature is available on CNC Bender software versions 10-20070425 and higher. The feature is available for installation on older systems, but requires that the older system electronics be upgraded.
