Difference between revisions of "VTube-LASER Precision Weight Control Alignment"
(→Values) |
(→Values) |
||
| Line 65: | Line 65: | ||
The T1 and T2 TRANSLATE values control the influence that tangent 1 or tangent 2 have in each straight. This is a translation influence - which means it controls the influence along the X, Y, and Z axes without rotation.<br><br> | The T1 and T2 TRANSLATE values control the influence that tangent 1 or tangent 2 have in each straight. This is a translation influence - which means it controls the influence along the X, Y, and Z axes without rotation.<br><br> | ||
| − | The STRAIGHT VECTOR values | + | The STRAIGHT VECTOR values allow each straight to have more or less influence with rotational or angular alignment. (This is referred to as transformation influence - which means the change is rotational or angular.) |
<br><br> | <br><br> | ||
Set these values to change the alignment. Then press recalculate alignment. | Set these values to change the alignment. Then press recalculate alignment. | ||
Revision as of 15:26, 19 August 2019
|
|
|
Contents |
This feature was added in VTube-LASER v2.8.
PRECISION WEIGHT CONTROL Alignment
|
PRECISION WEIGHT CONTROL alignment allows you to completely turn off certain sections of the tube for alignment or give emphasis to any section just by setting weights from 0 to 1000. |
|
| This shows emphasis given to end B. |
|
| This shows emphasis given to the middle straight. |
|
Values
|
The T1 and T2 TRANSLATE values control the influence that tangent 1 or tangent 2 have in each straight. This is a translation influence - which means it controls the influence along the X, Y, and Z axes without rotation. The STRAIGHT VECTOR values allow each straight to have more or less influence with rotational or angular alignment. (This is referred to as transformation influence - which means the change is rotational or angular.)
|
|
Popup Menu
|
As of 2.9.17, VTube also includes a popup menu to make changing the values easier. |
|
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
