Difference between revisions of "VTube NUMALLIANCE Bender Correction"

This page describes how to use VTube-LASER to correct NUMALLIANCE benders.

VTube-LASER has an export option for NUMALLIANCE MES files that are used to correct the NUMALLIANCE benders.

Note: NUMALLIANCE benders only require the measured data for corrections.

Measure the tube in VTube-LASER, then send the MEASURED tube data to the bender control, and it will then perform the correction.

Follow the steps below.

Press the Bender Setup button. (These steps assume that you have measured the tube and have setup VTube-LASER with the NUMALLIANCE protocol.)

Set the bender number. It should say NUMALLIANCE like shown here.

If the data in the window is not correct, then import the data from the main VTube-LASER memory by clicking on "Setup this Window" then clicking on "Copy Master LRA to Setup LRA".

In the "Correct the Bender" menu, click on Auto Send.

A save file dialog will open and allow you to name the MES file on a thumb drive or on the network. This file will be imported into the NUMALLIANCE control.

At the NUMALLIANCE control, press the CAD button.

Press the XYZ/LRA button.

Press the File button.

Press the Import corrections button.

Open the file from VTube.

Save the CSV file.

Import the file into the NUMALLIANCE control.