Difference between revisions of "VTube Communications With Transfluid Benders"
(→STEP 2) |
(→STEP 3) |
||
Line 102: | Line 102: | ||
</table> | </table> | ||
− | ====STEP 3==== | + | ====STEP 3: Set the Import Box Settings==== |
<table width=1000> | <table width=1000> | ||
<tr valign=top> | <tr valign=top> | ||
Line 114: | Line 114: | ||
*Bender Number: Each bender number should have a unique number in the Supravision protocol. | *Bender Number: Each bender number should have a unique number in the Supravision protocol. | ||
*Timeout: 10 seconds is high enough. (tProject is very quick for communications. Lower timeouts may be ok too.) | *Timeout: 10 seconds is high enough. (tProject is very quick for communications. Lower timeouts may be ok too.) | ||
+ | <br><br> | ||
+ | Note: This protocol allows for both automatic import and export. It is only necessary, however, to change the settings inside the "Import" section. You can ignore the rest of the settings on this page. | ||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
Line 120: | Line 122: | ||
</tr> | </tr> | ||
</table> | </table> | ||
− | |||
====STEP 4==== | ====STEP 4==== |
Revision as of 20:47, 29 March 2021
This page describes the use of the VTube-LASER to Transfluid bender corrections. |
Back to VTube-LASER
Contents |
CONFIGURING VTUBE-STEP AND VTUBE-LASER for COMMUNICATIONS with TRANSFLUID tPROJECT
As of version 3.0 build 456, we've embedded the Transfluid SVNET protocol in VTube-STEP and VTube-LASER.
You can set this protocol in the Benderlink setup grid in System Options.
You can perform this setup from VTube-STEP or VTube-LASER. The steps are identical in both.
STEP 1: Enter the SYSTEM OPTIONS Menu in VTube
|
STEP 2: Setup the Benderlink Network Grid for Transfluid Supravision Network Protocol
|
CONFIGURING TRANSFLUID TPROJECT FOR COMMUNICATIONS WITH VTUBE-LASER AND VTUBE-STEP
Follow these steps in Transfluid tProject to set up communications for VTube-LASER and VTube-STEP |
tProject Configuration STEPS
STEP 1: Enter Options Window
Click on the blue button wrench/screwdriver button in the upper right corner of the user interface. |
STEP 2: Enter the Import/Export Tab
Click on the Import/Export tab. |
STEP 3: Set the Import Box Settings
Enter the set up data in the Import box.
|
STEP 4
Close the options menu with the OK button and check for the Supravision communications LED in the lower right corner of tProject. The LED should be green. |
How to Prepare tProject to Receive New Data from VTube
The Transfuild tProject program can receive data for a part that has never been sent to it before from VTube-STEP. In tProject
|
How to Send New Data to tProject from VTube-STEP
The Transfuild tProject program can receive data for a part that has never been sent to it before from VTube-STEP. This allows a user to import a solid model of any tube, then send it to tProject. VTube-STEP
|
Other Pages
- See VTube-LASER
- See VTube-STEP