Difference between revisions of "CNC Bender v10-20071003"
(→CHANGES to CNC PROCESSOR) |
|||
| Line 44: | Line 44: | ||
<td width=100> | <td width=100> | ||
</td> | </td> | ||
| − | <td width=300> | + | <td width=300 bgcolor="#f0f0f0"> |
[[image:Gear_warning.jpg]] IMPORTANT REMINDER: Do not work in a bending machine when it is only in [[Cycle Hold]]! If the machine is power on and not in [[Safe Mode Cycle Hold]], then it is critical to keep hands out of the working area of the machine. Always press the E-stop before working on the machine. | [[image:Gear_warning.jpg]] IMPORTANT REMINDER: Do not work in a bending machine when it is only in [[Cycle Hold]]! If the machine is power on and not in [[Safe Mode Cycle Hold]], then it is critical to keep hands out of the working area of the machine. Always press the E-stop before working on the machine. | ||
</td> | </td> | ||
Revision as of 23:01, 3 October 2007
Contents |
CHANGES to CNC BENDER
Automatic Cross Check for Module Configuration Files
CNC Bender can get confused if the module configuration files are setup improperly. CNC Bender now performs a module configuration cross check diagnostic every time it starts.
If the configuration files are not perfectly matched, then you will see this warning:
Update to File Load User Window
The File Load menu User Interface adjusted slightly in order to be more consistent with other CNC Bender menus.
Changed from:
to
CHANGES to CNC PROCESSOR
CNC Processor is the program that directly controls the bender actuators.
Disallow Jog Queuing When in Cycle Hold Mode
CNC Bender no longer allows an operator to jog any axis or actuator if the Cycle Hold button is pressed. This mode is slightly different than Safe Mode Cycle Hold, where the safety scanner area is entered. When the safety scanner or mat is activated, the machine changes to a near Zero Energy State state.
Cycle Hold without stepping on the mat or safety scanner acts as a pause button without changing the bender into safe mode.
|
|
How to UPGRADE
If your operator station contains one of the versions listed below, then they can be upgraded through simple self-installation:
- CNC Bender v10-20070920
- CNC Bender v10-20070726b
- CNC Bender v10-20070803
- CNC Bender v10-20070828
- CNC Bender v10-20070914
Please contact Advanced Tubular Technologies for upgrade information.
