Difference between revisions of "VTube-LASER Leapfrog"

• Back to VTube-LASER
• See also Calibration-Leapfrog-Move Targets

• As of version 1.91 (June 30, 2014), VTube-LASER can leapfrog the arm over the tube in the middle of any measurement. In order to accurately leapfrog the arm over the tube, it is necessary to pause the regular measurement and measure 3 more more points in space using the ball probe before and after the leap or move. Then, after the leap, the arm measures the same points in the same order.
  
  
• Any number leaps can be combined to measure any distance.
  
  

Press the Move button in the guide box at any time during a measurement.

Place at least 3 targets as far from the arm as possible in the direction you want to leap.

Press the LEAP button in the guide window on the left.

Measure the targets with the ball probe. Press the green button to measure each target.

Press the red button to finish the initial measure.

Without moving the targets or the tube, leap the arm over the targets to a new position.

Measure the targets with the ball probe. Press the green button to measure each target.

Press the red button to finish the measure.

The leap is complete. Continue measuring where you left off before.

These are the leapfrog plates that we offer on our store. The plates have three numbered conical seats or spheres. With the conical seats the ball probe needs to be used and with the spheres, the laser can be used.