Difference between revisions of "VTube-LASER- Measuring Long Tubes"

• Back to VTube-LASER
• See also Calibration-Leapfrog-Move Targets

• When measuring long tubes, it may not be possible to reach the full tube without moving the arm or tube. The steps below show the process of measuring and moving a tube to produce measured data. This process is not as accurate as using Leapfrog but can still be used to measure long tubes.
  
  
• Any number of moves can be combined to measure any distance.
  
  

Press the Move button in the guide box after measuring at least 3 straights.

• Measure at least three straights.
• Press Move in the Guide Box
• Click "Measure Previous Bend and Move"
• Move the Tube
• Press Continue.
• Move back two straights and begin measuring again.
• Finish measuring the tube, or if needed, move the tube again and continue scanning.
  
  

These are the leapfrog plates that we offer on our store. The plates have three numbered conical seats or spheres. With the conical seats the ball probe needs to be used and with the spheres, the laser can be used.