Difference between revisions of "Inspection Tolerances"
From ATTWiki
(→Radial) |
(→Radial) |
||
| Line 26: | Line 26: | ||
<td width=300> | <td width=300> | ||
===Radial=== | ===Radial=== | ||
| − | '''This value changes the tolerance the shape of the tube is qualified to.''' | + | '''This value changes the tolerance the shape of the tube is qualified to.''' <br><br> Change the value and press F2 on the keyboard or Refresh Parametrics in the upper right hand corner of VTube</td> |
<td> | <td> | ||
[[image:vtubeinspectiondata.png|700px]] | [[image:vtubeinspectiondata.png|700px]] | ||
Revision as of 15:29, 20 February 2023
|
|
|
Different Tolerances
The tolerances inside the Inspection Tab can be adjusted to qualify parts to different standards.
RadialThis value changes the tolerance the shape of the tube is qualified to.Change the value and press F2 on the keyboard or Refresh Parametrics in the upper right hand corner of VTube |
|
LinearThis value effects the ends of the tube.Change the value and press F2 on the keyboard or Refresh Parametrics in the upper right hand corner of VTube |
|
AngularThis value effects the angle tolerance. These values can be adjusted independently. Change the value and press F2 on the keyboard or Refresh Parametrics in the upper right hand corner of VTube |
|
|
|
