Difference between revisions of "Main.axislist"
From ATTWiki
| Line 1: | Line 1: | ||
[[image:cncbender_logo.jpg|400px]] | [[image:cncbender_logo.jpg|400px]] | ||
__notoc__ | __notoc__ | ||
| − | |||
| − | |||
<table cellpadding="5"> | <table cellpadding="5"> | ||
<tr><td width=25></td> | <tr><td width=25></td> | ||
<td width=300 bgcolor="#f0f0f0"> | <td width=300 bgcolor="#f0f0f0"> | ||
| − | <font size=5>[[image:Gear_warning.jpg]] <b> | + | <font size=5>[[image:Gear_warning.jpg]] <b>WARNING</b><br><br></font> |
<font size=3>This information is highly technical. Please '''DO NOT''' make changes to this file unless you are confident that changes must be made!<br><br> | <font size=3>This information is highly technical. Please '''DO NOT''' make changes to this file unless you are confident that changes must be made!<br><br> | ||
If you have a doubt, then ask us first. Then you can make the change with confidence.</font></td></tr></table> | If you have a doubt, then ask us first. Then you can make the change with confidence.</font></td></tr></table> | ||
Revision as of 18:56, 3 November 2007
|
|
What is It?
The main.axislist file exists in the c:\cnc\config\axis folder. It contains setup information for each of the controlled axes on a CNC bender.
Sections
Each of the sections in the main.axislist is set apart with an axis section label like this:
[Axis 1]
Each section has individual properties that pertain to that axis.
Properties
Example properties for an axis:
[Axis 1] Type=Feed Module Name=servo_controller_module_1 Module Axis=1 Position Multiplier For Display= 1.0 Position Rollover= 32000 Position Rollover Tolerance= 100 // Move Feed Axis forward 0.25 forward and make that ZERO // This prevents ever getting into slight negative region // which causes rollover problems. Position Offset=0.25 Position Offset Speed=400 Datum Offset=0 Home Required=1 Monitor Fault State=1 Monitor Enable State=1 Monitor In-Position State=0 // 1 = -10 to +10 volts Analog Clamp Voltage Setup=1 Digital To Analog Datum=8191 Is Linear = 1 Delay After Cycle Start = 0 Dont Move If Position Within Tolerance Value = 0.5
Note that remarks may be added to the file with lines preceded by double forward slashes.
// Move Feed Axis forward 0.25 forward and make that ZERO
