Difference between revisions of "CNC Bender v10-20071120"
| Line 27: | Line 27: | ||
The machine lube setup is control from the CNCProcessor.cfg file in the c:\cnc\config folder. | The machine lube setup is control from the CNCProcessor.cfg file in the c:\cnc\config folder. | ||
| + | |||
| + | |||
| + | <table cellpadding="15"> | ||
| + | <tr><td width=5></td> | ||
| + | <td width=300 bgcolor="#f0f0f0"> | ||
| + | <font size=5><b>New Settings</b><br><br></font> | ||
| + | The "Use Pulse or Constant Output" is a new capability</b> | ||
| + | </td></tr></table> | ||
===[[image:Check.jpg|25px]] Changed a Range Error Message for Clarity=== | ===[[image:Check.jpg|25px]] Changed a Range Error Message for Clarity=== | ||
Revision as of 02:57, 23 November 2007
Contents |
CHANGES to CNC BENDER
Redesigned Processor Menu
The CNC Processor menu is redesigned to include 5 new tab menus.
The INCOMING MESSAGES menu now allows you to show an extended history log:
The new MACHINE LUBE tab has new controls and features:
The machine lube setup is control from the CNCProcessor.cfg file in the c:\cnc\config folder.
|
New Settings |
|
Immediate Message |
Production Cycle Time Value
The "Complete Cycle Time" is changed to "Production Cycle Time" and now provides the overall time from part to part.
New General Dynamic Option - PD Set Pressure
If this option is enabled, then the PD Set Pressure Output Points are enabled using the new SetPDPressureOutputPoints command.
Changed Terminology
The following terms are changed in CNC Bender user interface:
| ORIGINAL | NEW | |
| In Low Level Tangent to Collet Face |
In Low Level Machine Length |
|
| In Run Page Complete Cycle Time |
In Run Page Production Cycle Time |
CHANGES to CNC PROCESSOR
Optimized for Win2000 or WinXP
This CNC Processor recognizes the current operating system and optimizes the loop for each operating system.
How to UPGRADE
If your operator station contains one of the versions listed below, then they can be upgraded through simple self-installation:
- CNC Bender v10-20071003
- CNC Bender v10-20070928
- CNC Bender v10-20070920
- CNC Bender v10-20070726b
- CNC Bender v10-20070803
- CNC Bender v10-20070828
- CNC Bender v10-20070914
See our CNC Bender Upgrade Policy page for details regarding the charges for the upgrade software.
Download the setup file by clicking on this link.
This setup file requires a password to run.
Please contact John Esralian for upgrade prices and password information.
For instructions on how to install the file see: How to Install a CNC Bender Upgrade
